3/11/2023 0 Comments Armytek wizard pro 1200![]() Either way, be aware that once your light steps down off the desired output (ie ~81m in the above test), stop using it and charge the cell.īuilt-in charging is a feature of the Wizard Pro. I can’t speak to that – I will contact Armytek about this. It’s been suggested that I got a dud light since Wizards do usually have LVP. I pulled the light off the apparatus when the switch was blinking (for some time I don’t know how long), and the cell was 1.34V. In the next lowest output – Turbo1 – the light also exhibited no LVP. In this test, the cell was 2.33V when I checked it, which was quite some time after the test ended. Another thing to note is that neither of my tests exhibited any LVP whatsoever. So while I’m reporting 1213 lumens (which is almost within the 10% rule anyway), I think 1400 is most certainly accurate.Ī couple of other things: I like that the output doesn’t step down at 30s exactly – output is maintained for over a minute! That’s good. So this is close but likely there was some spill that didn’t get picked up. The girth of the neck, where the cooling fins are, thwart usual means of calibrated runtimes on my setup. ![]() One thing about these runtimes, which I alluded to above. You should plan to use a high-quality cell, though – the light draws nearly 5A on turbo2. I tested with my shortest flat top unprotected 18650 and my longest protected button top, and they both work fine. However, due to the setup in the cell tube, any type 18650 will work. The cell has PLENTY of room in the cell tube.ġ08mm long, 24.5mm in body diameter, 29mm in head diameter. The head end has only a button – no spring. this light can be mechanically locked out with just a small twist. However, unlike most unanodized threads…. The threads on the body are unanodized, square-cut, and quite long – so a bunch of twisting is required in order to remove the cap.Īlso since these are bare threads, they don’t feel quite as smooth as I might like. The tailcap must be twisted for charging. The Wizard Pro Nichia Warm has Armytek’s signature extreme levels of printing. More on this in the charging and retention sections. The tail end has a magnetic charge connector. The body is more or less featureless, due to this being a headlamp going to live on a headband most of its life. The optic covering this emitter is dimpled, and not just that – there’s also a nice anti-reflective coating on there. Also, note how the fins extend past the bezel – this will come up later. There’s a good amount of cooling area below the head – more than just fins there’s quite a bit of mass there.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |